![]() I do not know for sure that this will work for you but I think the tomtom and the garmin would act the same. Install your software and you should be able to work on it from there. (This could take a minute or so) You should see that it is loading the drivers and tell you when they are installed.Ī this point you should see the device as a large storage device in the file manager. Then close the section and click it again to see the right one.Ĭlick it to select and wait for it to load the drivers. If there are a lot and you can not determine which one it is you can unplug the tomtom and see which one disappears. Start the guest and wait for it to settle down.Īt the top click devices and the go to USB and look for the one that says 930 (more than likely unknown) Just make sure that the check marks are in the enable USB controller and the Enable USB2 Leave the filters with nothing in it. I did not put any filters in the USB settings. I plugged it in before I started the guest. Here is what I did to get it going in the guest. Ubuntu 9.04 actually sees my unit and is fully functional and VirtualBox program does see it as an unknown device. In this case it's best to contact our technical support to verify the troubleshooting and get help resolving this.Ok I have hooked up my Garmin to Windows XPpro 圆4 running on Ubuntu 9.04 host. If your device is still not recognised after going through the steps in the previous sections, the issue may lie with the device itself.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |